TECHNICAL SPECIFICATION of Abrasive Cnc Water Jet Cutting Machine :
DIPS9-3040 High Pressure
- Far Higher Efficiency
- Very Low Operating Cost
- Smooth and Consistent pressure at the Nozzle
- Easy to carry out maintenance
- Max. Output pressure: 55000 psi (380 mpa)
- Pressure Intensification ratio: 20:1
- Max. Flow rate: 3.7 lpm
- Inlet water pressure: 0.4 mpa (For Intensifier)
- Triple cartridge inlet water filtration to 0.5 micron with inlet and outlet pressure gauges.
- Pressure control valve.
- Pump is mounted on its own skid for vibration isolation and easy service.
- Main motor power: 30kw / 40HP
- Voltage: 415 VAC, 50Hz, 3 Phase (Standard) or as per your Purchase Order
- Inlet Water pressure for heat exchanger :0.8 mpa
- Oil Recycling: 69 liters/min.
- Main parts of intensifier imported from abroad (High-pressure (HP) cylinder, plunger, HP seals, HP tube)
- Integral Inlet water filters (5Micron, 1micron, 0.45micron in series)
- Working hour counter
- Special tool kit for maintenance / repair
- Arbitrarily hands adjusting working pressure
- Automatically shut down (Trip Off) in case of super pressure of oil or low pressure of water for protection
- Dimensions: (Approximately)
• Length – 1700mm
• Width - 1000mm
• Height – 1200mm