Hot/Cold Bath for Pressure Test as per plastics are affected by the temperature, Hydrostatic Pressure tests for HDPE, R-PVC, C-PVC, U-PVC, MDPE and lateral pipes test specimens are suppose to be tested either at room temperature, at higher temperature or lower temperature in water bath as per national & international standards.

USP:
"Saumya" baths are uniquely designed to heat faster with low energy cost and to maintain the temperature for longer time. To maintain the the temperature into the bath circulation is done by either one or two pumps as depending on the volume of bath.

Temperature is controlled by microprocessor based controllers. In large size bath "Saumya" gives separate bath for heating & the hot water is circulated to the other chamber so as to save the energy cost.


Specification:
Model No. SWB - A SWB - B SWB - C SWB - D
Temp. Range Amb-100°C Amb-100°C Amb-100°C Amb-10°C
Control PID PID PD Prog. Cont. for cooling
Water Circulation C.G. make Pump C.G. make Pump C.G. make 2 Pumps C.G. make Pump
Material of Construction Inner S.S. & Outer M.S. with powder coating

Power Supply : 440 V AC, 50 Hz

Inner Dimension :
Or As per Requirement 4ft. X 1ft. X 1.5ft. 4ft. X 3ft. X 1.5ft. 6ft. X 4ft. X 4ft. 6ft. X 4ft. X 4ft.
Net Weight 60 Kgs. 100 Kgs.ect..