Monoblock Gas Burner By Diligent Micro Controls

Our Mono block gas burner has centrifugal blower with suction damper for supplying combustion air. Cylindrical blast tube of appropriate dimensions is fixed on the discharge port of the blower. This blast tube carries assembly of gas pipe, ignition electrode and flame rod. Gas solenoid valve is installed at one end of the gas pipe where as its other end is blind and carries a specially perforated disc called a Diffuser Platea . Close to the diffuser plate but on inner side, small holes are made along the periphery of the pipe to allow gas discharge. The gas coming out from these holes thoroughly mixes with air discharged by the blower and the mixture comes out uniformly through the diffuser plate. When air / gas proportion is set correctly set, it can be ignited by a small spark. A Single Pole electronic ignition transformer of 100% duty cycle and ignition electrode, are used to produce this spark just in front of the diffuser plate. Another electrode is placed through diffuser plate such that it makes contact with the flame to collect ions in the flame. This is a Flame Electrodea . Diligent Autocon burner controller is used to monitor the safety inter locks such as Air Pressure Switch and correctly switch blower, ignition transformer and gas solenoid valve. These are available in different sizes starting from 50,000 k cal/hr to 5 lac k cal/hr.