SPECIFICATIONS of Double Shaft Lathe Machine :
Height of Centre : 212 mm.
Swing Over Bed : 410 mm.
Swing Over Slide : 240 mm.
Movement of Cross Slide : 240 mm.
BED :
Bed Type : 2 V & 2 Flat
Bed Width : 280 mm.
Length of Gap in Bed : 110 mm.
MAIN SPINDLE :
Size of Threaded Spindle Nose : 6 TPI 75 mm.
Taper Bore in Spindle Sleeve : MT � 4
Spindle Bore : 52 mm.
TAIL STOCK :
Ram Diameter : 50.8 mm.
Taper Bore in Spindle Sleeve : MT � 4
Ram Travel : 150 mm.
COMPOUND SLIDE :
Travel of Compound Slide : 150 mm.
Tool Shank Section : 25 x 25 mm.
SPEEDS :
No. of Speeds / Range : 6 / 40 � 550 RPM
THREAD / NO. RANGE :
Lead Screw Diameter & Pitch : 31.75 mm. X 4 TPI
Metric : 19 / 0.50 to 8.0 mm.
Inch : 23 / 4 to 40 TPI
ELECTRICAL :
Power Required : 2 H.P.
SPECIAL FEATURES :
BED: Made of Close Grain Alloyed, Cast Iron up to required Hardness and Seasoned after rough machining to avoid Stresses.
CARRIAGE : Mounted on invert V and flat guide way of the bed. Carriage is wide enough to have a maximum bearing surface with rigid tool support. The slides are accurately scrapped.
HEAD STOCK: Four Step Head Stock precision Bearings Mounted on Hardened and ground Spindle. Hob Cut Back Gears for low Speed.
APRON : Oil bath type designed with independent drive motion for feeds and screw cutting with interlocking arrangements. Worm and worm gear is used to engage auto feed for surfacing.
|
