This conductor is made from aluminium  - magnesium - silicon alloy of high electrical conductivity containing enough magnesium silicideto give it better mechanical properties after treatment. These conductors are generally made out of aluminium alloy 6201. AAAC Conductor has a better corrosion resistance and better strength to weight ratio and improved electrical conductivity than ACSR Conductor on equal diameter basis.

This conductor is also known as aluminium stranded conductor. This conductor is manufactured from electrolytically refined (E.C. GRADE) aluminium, having purity of minimum 99.5% of aluminium. This conductor is used mainly in urban areas and the spacing is short and the supports are close. All aluminium conductors are made up of one or more strands of aluminium wire depending on the end usage. These conductors are also used extensively in costal because it has a very high degree of corrosion resistance.

This conductor consists of a solid or stranded steel core surrounded by strands of aluminium (E.C. GRADE). ACSR Conductors is available in a wide range of steel varying from as low as 6% to as high as 40 %. The higher strength ACSR C onductors are used for river crossings, overhead ground wires, installations involving extra long spans etc.. against any given resistance of conductor, ACSR C onductor may be manufactured for having a wide range of tensile strength as per requirement. The principal advantage of these conductors are high tensile strength and light weight with l

"Jenco" make H.T. Gang Operated Air Break off-load, Rotating type, Double Break Isolator suitable for out door horizontal mounting confirming to IS-1818/72 & IS9921-1985. Complete with manual operating mechanisms, G.I. Arcing Horns & Terminal connectors for ACSR conductors. The Isolators are manufactured in 11/22 & 33 KV ( Isolators can also be manufactured with solid core post insulators as per International standards.) in 11/ 22 & 33 KV.etc.

"Jenco" make Gang Operated Air Break off load disconnecting Switch tilting type, each pole consists of hot dip galvanized steel channel base with three insulators per BSS/ISS, non-ferrous knife and spring loaded contacts, arcing horns of adequate section to break magnetizing current of the transformer. Horizontal G.I Pipe of adequate length for phase separation and operation form ground level with operating handle complete in both ON and OFF position. All ferrous parts are tinned duly to withstand weather conditions. Manufactured generally in accordance with IS suitable for h