Batch Crystallizer The set-up is designed to demonstrate and stimulate the phenomena of crystallization. This operation involves both heat and mass transfer. Crystallization is the formation of solid particles within a homogeneous phase. Its wide use has a two-fold basis; a crystal formed from an impure solution is itself pure. The setup consists of an open, jacketed and conical bottom vessel fitted with a low RPM agitator and a heater. Arrangement for Cooling water circulation and flow measurement in jacket is made by using storage type water tank, a pump and a rotameter. The feed/mothe

Centrifugal Pump Test Rig The setup is designed to study the performance of centrifugal pump. Set up consists of a centrifugal pump coupled with electrical motor, supply tank, measuring tank & pipe fittings for closed loop water circulation. Pressure and Vacuum gauges are connected on delivery and suction side of pump for the purpose of measurement. The flow rate of water is measured using measuring tank and stop watch provided.

Hammer Mill Hammer Mill consists of Pivoted hammers, mounted on a horizontal shaft. Crushing takes place by impact between the hammers and anvil plate. The hammers delivers heavy blows to the feed material while it is in suspension, driving it against an anvil plate until it is fine enough to pass through the opening of the mesh fitted in the bottom of the Mill. The present Hammer Mill has a sturdy housing which contains 4 Nos. of T shaped hammers pivoted to a disc which is fitted with the shaft of the mill turning about the horizontal axis. The shaft is directly coupled to a motor. The hou

Heat Transfer Lab Equipments Heat Transfer Labs:- Heat Transfer Through Composite Walls, Heat Transfer Through Lagged Pipes, Heat Pipe Demonstrators, Thermal Conductivity Of Insulating Powder, Thermal Conductivity Of Metal Rods, Thermal Conductivity Of Insulating Slabs, Thermal Conductivity Of Liquids, Heat Transfer From A Pin Fins, Heat Transfer In Forced Convection, Heat Transfer In Natural Convection, Emissivity Measurement Apparatus, Stefan Boltzman Apparatus, Finned Tube Heat Exchangers, Vertical Condensers, Horizontal Condensers, Open Pan Evaporators, Multi Effect Evaporators

Jet Pump Test Rig The setup is designed to study the performance of jet pump. Set up consists of a Mono-Block jet pump coupled with electrical motor, supply tank, measuring tank & pipe fittings for closed loop oil circulation. Pressure and Vacuum gauges are connected on delivery and suction side of pump for the purpose of measurement. The flow rate of water is measured using measuring tank and stop watch provided.