PROCESS DESCRIPTION- Atmospheric Air mainly consists of Oxygen and Nitrogen gases along with small quantities of water vapour, Carbon Dioxide, Argon, Helium, etc. Oxygen and Nitrogen from the air separated due to difference in boiling points by distillation through a fractional column. Atmospheric air is sucked in by multi stage Compressor through a filter and is compressed to the design pressure. The Compressed Air then passed through after cooler, Moisture Separator, Cascade Cooler, Freon Chilling unit, Moisture Separators, and them to the Molecular Sieve Battery for remov

Introduction- The Kanak Cryo Sales, Service & Consultancy manufactured plant very safe and economical, is a medium pressure plant, with an efficient expansion engine, that lowers operating pressures to a remarkable 35 to 38 Kg/cm2. This reduces power consumption and adds to safety. In the Kanak Cryo Plant is a molecular sieve battery assembly for adsorption of moisture and carbon dieoxide. This plant provides easy access for maintenance. Capable of simultaneously producing oxygen and Nitrogen, the Kanak Cryo plant has an internal Compression liquid oxygen pump to fill dry ga

NITROUS OXIDE GAS PLANT KCS Nitrous Oxide Plant are very Safe to operate and economical Plant. With an efficient Generation system, which reduces, power consumption and adds on to safety. The gas manufactured conforms to Indian pharmacopia and is stored in liquid state, which can be directly filled into cylinder. Process Description- It is produced by heating Ammonium Nitrate to a temperature of approximately 250 deg.C. Ammonium Nitrate is decomposed in the process to give a mixture of Nitrous Oxide and super heated steam. At the same time impurities are produced incl

MOLECULAR SIEVE BATTERY To remove moisture, Carbon di-oxide & traces of Acetylene and other hydrocarbons consisting of 2 dries filled with molecular sieve along with regenating electric heater. Temperature sensors & control panel with temperature controller. Each vessel of Molecular Battery is filled with molecular sieve of 1.5/3 mm type 13-X. This is regenerative type capacity 400m3/hr to 200 m3/hr and 12 hour regeneration cycle.

EXPANSION ENGINE- The expansion Engine is vertical, single acting, reciprocating type. This produces the cold required for the plant. High pressure air enters through inlet valve at the start of downward stroke of the piston. On further downward motion, the inlet valve closes and entrapped Air expands. During upward stoke , outlet valve remains open and inlet valve remains closed. Therefore, in downward stroke Air enters the cylinder and expands. In the upward stroke the expanded air is pushed outside. The electric Motor is used to start the machine. Thereafter t